V2T-100
Single phase transitory, Class I, 100kA
Description
Strong>Temporary overvoltage protection, class III, for Ethernet Cat.6 signal lines
It is installed in the meter area, in parallel with the supply network, so the service current does not pass through the equipment.
It is necessary to install a Class II protector downstream of this device.
This equipment DOES NOT PROTECT against voltage surges PERMANENTS.
SPECIFICATIONS>/th> | strong>Values |
---|---|
Nominal voltage Un | 240 VAC (L1/N, L2/N, L3/N) |
Maximum voltage Uc | 385 VAC (L/N) |
Frequency | 50-60 Hz |
Level of protection Up | ≤2kV (L/N) ≤ 2.5kV (PE/N) |
Pulse intensity (10/350µs) Iimp | 50 kA (L/N) 100kA (N/PE) |
Nominal intensity In (8/20µs) | 50 kA |
Surge response time | ≤100 ns |
Maximum pre-fuse | 500A gL |
Maximum cable section in terminals | 35 mm2 |
Temperature ranges | -40º +85ºC |
Grade of protection | IP20 |
Assembly | Rail DIN 35 |
Product standards | IEC 61643-11 / EN 61643-11 |
Type/Class | I |
Codes and references
10002711 | V2T-100 |
---|